Skip to main content
Unifrost Commercial refrigeration knowledge hub for Irish businesses
  • Unifrost/
  • FAQs /
  • How do I change or check the temperature setpoint on a Unifrost upright freezer’s digital controller?
FAQ

How do I change or check the temperature setpoint on a Unifrost upright freezer’s digital controller?

Updated 08 Jul 2026 FAQs Reviewed for Unifrost.ie
FAQ
Quick answer

Unifrost uprights in this family commonly use Dixell, Elitech, or Carel controllers. The exact button names vary, but the owner-safe workflow is usually the same:

Support note

This FAQ is designed for a fast answer first. Use the related guide links if you need the fuller decision path behind the short version.

Unifrost uprights in this family commonly use Dixell, Elitech, or Carel controllers. The exact button names vary, but the owner-safe workflow is usually the same:

Check the current setpoint: press and hold SET (or the setpoint/target key) for 1 to 3 seconds until the setpoint value appears.

Adjust (if permitted): use ▲/▼ to change the setpoint.

Save: press SET again (or wait 5 to 10 seconds) to store it.

Confirm you are reading the right value: most displays show cabinet air temperature, not product temperature.

Safe boundaries for hotel use:

Make changes in small steps (1°C at a time) and wait for the cabinet to stabilise.

Avoid entering “parameter/programming” menus unless you have the exact controller guide for your unit. Incorrect parameter changes can cause nuisance alarms, poor defrost performance, or temperature instability.

Read the full guide: Unifrost F410SS Upright Freezer: Quick Start Guide for Hotels.

Related Guides

Read the fuller guide around this question

These articles are the best next reads if the visitor wants a deeper product choice, maintenance, or support route from here.